Lower Mainland Airsoft Group Forum

need more topics for the tech corner.



if you would like to see something in particular please post it up...

How about how to install your own hop up rubber in a gbb pistol I know some people may be having that issue

I'm on my phone so I don't feel like going through and checking what's been done, so if so, my bad....

-mosfets
-gearbox timing
-gearbox shimming
-correcting AOE with use of Sorbo pad
-upgrading wiring and types to use
-optics vs iron sights
-gearing in comparison to motors

I think you did a write up on tight bores or maybe cylinders, but what about one that talks about to long or short of barrels compared to types of cylinders?

Tjfast wrote:I'm on my phone so I don't feel like going through and checking what's been done, so if so, my bad....

-mosfets
-gearbox timing
-gearbox shimming
-correcting AOE with use of Sorbo pad
-upgrading wiring and types to use
-optics vs iron sights
-gearing in comparison to motors

I think you did a write up on tight bores or maybe cylinders, but what about one that talks about to long or short of barrels compared to types of cylinders?

MOSFETS....DONE
GEARING RATIOS----DONE
MOTOS----DONE.

EVERYTHING ELSE ILL LOOK INTO.

Steel wrote:How about how to install your own hop up rubber in a gbb pistol I know some people may be having that issue

too many variants in pistols. and quite frankly I don't know how to install the hop up rubber in each.

I can type up something in the next few days about irons vs optics.

Gunny wrote:

Steel wrote:How about how to install your own hop up rubber in a gbb pistol I know some people may be having that issue

too many variants in pistols. and quite frankly I don't know how to install the hop up rubber in each.

Alright, i just cant seem to find it anywhere!

Meatshower wrote:I can type up something in the next few days about irons vs optics.

Thatd be a great topic. Slightly dependant on opinion, but id read that for sure.

How to install deans plugs