Lower Mainland Airsoft Group Forum

So I just bought a TM Glock 18c from apsram.ca in richmond, but as it turns out Trigger got them in at the end of this last week and is charging only $279. So I missed out on a $50 savings but if any of you were looking for one of these this is the best price I've seen in canada, and it is the black lower version, not the tinted one.

http://triggerairsoft.com/shop/Tokyo-Marui-G18C.html

Cheers,
DT

Couple things, go easy on full auto. Your sear will wear down fast/break. If you plan on keeping your plastic slide, it can break on propane, if you upgrade to a metal slide I would recommend a guarder Glock frame. The main frame post that you put your screw through will snap on the stock unit, especially with green gas.[img]

Gunny wrote:Couple things, go easy on full auto. Your sear will wear down fast/break. If you plan on keeping your plastic slide, it can break on propane, if you upgrade to a metal slide I would recommend a guarder Glock frame. The main frame post that you put your screw through will snap on the stock unit, especially with green gas.

Hadn't thought about changing out the frame, but I have done a few upgrades so far (waiting for a few more from china too)

PGC Metal Slide and Outer Barrel
Guarder 6.02 Tight Bore Inner Barrel
Guarder Enhanced Loading Muzzle
Guarder 150% recoil spring and guide
Guarder 150% hammer spring
Shooter's Design Steel Full Auto Sear
GunsModify Steel Hammer
GunsModify Adjustable Trigger (waiting for china shipping)
AIP Reinforced Hop-Up Bucking (waiting for china shipping)

I don't really plan on using full auto. The price was so close to the 17 I figured why not get the 18. I'll keep my eye out for a guarder frame at a good price.

Cheers