Lower Mainland Airsoft Group Forum

I am working on a VFC scar L. on the gearbox, there is a ambi selector switch that needs to be removed in order to take the gearbox apart.

the smallest allen key I have is .5mm and it is still too big. if you have something smaller than that can you please bring it to the field with you on the sniper course sunday so I can use it.

Hey Gunny,

check, you are needling a .5mm allen key??
I will be at the course tomorrow I have a 1.27mm and a 0.89 anything smaller is custom. I did make one that you can try.

I double checked, the smallest I have is 0.05mm. and it needs to be smaller. if you don't mind bringing them tomorrow so I can check that would be amazing.

this is the part im trying to take apart.

I had the exact same problem last year. I forget what size the allen key was, but I bought this allen key set and one of them worked.
http://www.kmstools.com/performance-too ... y-set-4990

the 3 smallest metric sizes are
1.3mm
.9mm
.7mm

and the 3 smallest imperial sizes are
.050"
.035"
.028"

hope this helps